DIN 17100 ST70-2 steel

DIN 17100 applies to ST70-2 steel sections (including wide flange beams), steel bars, wire rod, flat products (strip, plate, wide flats) seamless and welded, square and rectangular hollow sections, forgings and semi-finished products in the general structural steels of DIN 17100 ST70-2 which are delivered in the hot formed or normalized condition after production
[email protected]
0086-21-61182423
Live Chat  Leave a Message

DIN 17100 applies to ST70-2 steel sections (including wide flange beams), steel bars, wire rod, flat products (strip, plate, wide flats) seamless and welded, square and rectangular hollow sections, forgings and semi-finished products in the general structural steels of DIN 17100 ST70-2 which are delivered in the hot formed or normalized condition after production

DIN 17100 ST70-2 chemical composition

Grade

C

Si

Mn

P max

S max

Al

Cr

≤0.16

≤0.35

0.40-1.20

0.035

0.030

≥0.020

≤0.25

ST70-2

Cu max

Mo

Nb

Ni

Ti

V

-

0.30

≤0.10

0.01

0.30

0.03

0.03

-

DIN 17100 ST70-2 mechanical properties

Grade

Tensile strength

Yield point

ST70-2

t<3

3≤t≤100

t≤16

16<t≤40

40<t≤63

63<t≤80

80<t≤100

690-900

670-830

365

355

345

335

325

DIN 17100 ST70-2 steels are suitable for hot and cold forming, i. e. they must be neither cold-short nor red-short. In the bending test DIN 17100 ST70-2 much be capable of being bent for 180° round the mandrel diameters stated without showing any cracks on the side in tension.

DIN 17100 ST70-2 Flats up to 20 mm thickness from the steels with the code letter Q are supplied with special suitability for cold bending, folding, cold flanging or cold beading with internal bending radii in accordance. Flats with rolled-in pattern cannot be supplied in Q grades.

Strip from DIN 17100 ST70-2 steels with the code letter K is delivered in thicknesses up to 8 mm with suitability for the manufacture of cold rolled sections on rolled section machines (see DIN 59413) and in thicknesses up to 12.5 mm with suitability for the manufacture of cold forming hollow sections (see DIN 59411). The suitability applies to the bending radii-stipulated in DIN 59411 & DIN 59413. For strip thickness over 8 mm or 12.5 mm the internal bending radii according to Table 5 apply of DIN 17100.

Contact Katalor [email protected] to know more about DIN 17100 ST70-2 steels, and we welcome you to visit us at any time!

Contact Us