Many open spaces and related projects, including gardens and landscape construction, require a large amount of weather resistant steel plates as support. In the case of reconstruction, it is necessary to laser cut the weather resistant steel plates to obtain a better practical effect. Because weather resistant steel plate has strong utilization performance and strong correlation, it takes time and effort to thin. So, what should be paid attention to when cutting weather resistant steel plates?
First, for projects that require high cutting accuracy for weather resistant steel plates, in the case of edge-punching production and processing, the measured cutting length should be added with a molybdenum wire half-warp. Due to the high precision requirements, although the molybdenum wire is very thin, in order to improve the precision and product quality, this deviation cannot be ignored.
Second, it can prevent the molybdenum wire from breaking during cutting. The second is to check the equipment water tank every two days to check the condition of the cutting fluid.
Third, maintain the conductive block regularly. If the groove mark is too deep, it must be replaced. Because the groove is too deep, the cutting line will break. If the cut wear-resistant steel becomes spiral, it must be replaced immediately, otherwise the quality of the cut product will be affected.
Fourth, when cutting large and medium-sized product workpieces, you must see whether the length of the CNC lathe is sufficient to cut the product workpiece. When the product workpiece touches one side, the product workpiece is eliminated, and the vibration result on the other side is divided by 2.
Fifth, cutting aluminum. If the aluminum content is relatively small, a shorter conductive block must be prepared in advance. During the production process, because the alumina on the molybdenum wire has been cleaned, some gasoline was brushed on the molybdenum wire within half an hour. Other ingredients can also be used to remove alumina from the surface. When cutting aluminum, the molybdenum wire can be twisted into a ball, and then the ball is flattened and placed on the guide block. The application is very convenient and the cost is very low.
In summary, the above is the main content of the weather resistant steel plate cutting precautions.
